Electrolux ETG340 Mode D'emploi page 17

822_949_461 ETG340_Elux.book Seite 15 Freitag, 8. Mai 2009 6:47 18
Operation
Before using for the first time
remove any stickers on the appli-
ance and clean it thoroughly (see
"Cleaning and care").
Do not use any metal utensils on
the grilling surface to prevent dam-
age to the non-stick coating!
Preparing the table grill
0
Insert drip tray (2) in base frame (1).
Inserting the heater plate (4) in the
base frame (1).
Apply a little cooking oil to the sur-
face of the heater plate each time
before use with the aid of kitchen
paper for better non-stick proper-
ties.
Insert the thermostat with mains
cable (3) fully in the socket on the
appliance. The thermostat can only
be fitted when the heater plate (4)
is in the correct location in the
base (1).
Working with the table
0
grill
Connect the mains cable (3) to the
socket.
Turn the thermostat (3) to the
desired setting (1 to 5).
1 = lowest temperature
5 = highest temperature
The operating lamp (3/a) on the
3
thermostat is on while the grill is
heating up. When the temperature
is reached, heating takes place at
intervals to maintain the tempera-
ture constant.
To switch off the appliance, turn
the thermostat to "OFF".
Practical tips
• The grill bars (4/c) are ideal for the
preparation of meat, fish and poul-
try. Fat and juice can fall into the
drip tray through the grill webs.
This ensures a healthy, low-fat
preparation.
• The frying surface (4/b) is ideal for
example for the preparation of
eggs, ham, mushrooms, tomatoes,
onions, etc. It is also very well
suited for keeping food warm.
Cleaning and care
0
Remove the mains plug from the
socket.
Allow the appliance to cool down.
Disassemble the appliance. The
heater plate can only be removed
from the base frame after the
thermostat has been removed.
The heater plate can be cleaned in
the dishwasher or manually.
Thermostat, drip tray and base
frame should be cleaned with a
damp cloth (not safe for dish-
washer).
Dry all parts thoroughly before
reassembling the appliance.
Note that water must not penetrate
1
inside the thermostat under any
circumstances!
Never clean under running water or
even in rinsing water.
Storage
It is best to store the table grill
assembled.
Technical data
Mains voltage:
Power consumption:
g
230 V
2200 W
15