Zibro A 20 Manuel D'utilisation page 38

AT T E N T I O N !
- Always use a new filter when the filter must be replaced. Never re-use a dirty
filter, even after cleaning.
- Regardless of the frequency of use, we recommend replacing the HEPA filter
with a new filter at least once per season.
D. OPERATION
Push the plug into the socket.
Move the ON/OFF switch to the ON setting to activate the device. The ventilator LO or
HI light will switch on.
Negative ions are generated and air purification commences.
Use the ventilator button to set the desired speed. You can select the
(high). The appropriate light – LO (low) or HI (high) – will then switch on.
Switch the device off by moving the ON/OFF switch to the OFF position.
E. CLEANING
Switch the air purifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a mild cleaning
agent. Wipe the device with a slightly damp cloth. Never spray the device with water.
THE HEPA FILT E R
Clean the grill of the front panel with a vacuum cleaner. It is not possible to clean the HEPA
filter. It must be replaced when it becomes dirty (see section B).
Never use the device without the air filter.
4
38
(low) or the