Air Filter - Zibro A 20 Manuel D'utilisation

B. INSTALLATION
Remove the front panel
of the device.
Take the filter out of the device and remove the packaging.
Put the filter back into the device, with the white side facing up.
Attach the front panel by pushing the three hooks on the top into the recesses in the
device. Now click the bottom left and right of the front panel into position.
The device is now ready for use.
AT T E N T I O N !
The HEPA filter must be inserted correctly in order to guarantee that it will
function correctly.
C. AIR FILTER
The A20 air purifier is equipped with a 3 layer filter package to clean the circulated room air.
- HEPA (High Efficiency Particulate Airfilter) filter captures allergens like bacteria, dust
and pollen.
- Active carbon filter removes unpleasant odours from the air.
- Screen filter captures large dust particles.
The HEPA filter and activated carbon filter continue to work for a long period of time after
opening. Both must be replaced approximately 1 - 2 x per year. The frequency of use and
operating conditions determine how often a filter must be replaced.
Switch the device off and remove the plug from the socket.
Remove the front panel
of the device.
Next to the filter you will see a sticker printed with a small grey and brown square. If
the filter is one of these colours, replace it in the matter described in chapter B.
Install the new HEPA / active carbon filter (see chapter B) and close the front panel.
The dirty filter can be disposed with the household waste (not biologically
degradable waste) without any problem.
New filters can be purchased from your dealer.
with the aid of the fastening mechanism
with the aid of the fastening mechanism
on both sides
on both sides
4
37