Safety Notes - Marq Gesture Spot 400 Guide D'utilisation

User Guide (English)
Introduction
Box Contents
Gesture Spot 400
Power Cable
DMX Cable
Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit marqlighting.com.
For additional product support, visit marqlighting.com/support.

Safety Notes

Important: In addition to the notes below, please refer to the included safety & warranty manual for
additional safety information.

Carry this product by the hanging/mounting bracket or the handles only.

Use this product indoors only (IP20). To prevent risk of fire or shock, do not expose this product
to rain or moisture.

Do not use this product for permanent installations.

Connect this product to grounded and protected circuits only.

Always disconnect it from its power source before cleaning or replacing this product's fuse.
Replace the fuse with another of the same type and rating.

Before connecting the product to a power source, make sure the power cable is not crimped or
damaged.

Make sure the power outlet's voltage is within the range stated on this product (on its housing or
decal).

Never connect this product to a dimmer or rheostat.

Never disconnect this product from the power cable by pulling or tugging on the cable itself.

If you mount this product overhead, use a safety cable.

Always make sure this product is used in a location with adequate ventilation with at least 20"
(50cm) from adjacent surfaces. Make sure none of this product's ventilation slots are obstructed.

Do not use this product at ambient temperatures higher than 104 °F / 40 °C.

Do not allow flammable materials near this product during use.

Do not look at the light source when the product is on.

Do not touch this product while it is powered on or immediately after powering it off. The product
and its housing can reach high temperatures.

If you encounter a serious problem while using this product, stop using it immediately.

Do not open this product's housing. It contains no user-serviceable parts and will void your warranty.

If the lens, shield lens, or ultraviolet screen becomes cracked, scratched, or otherwise damaged,
stop using it immediately. Contact Marq technical support for service and repair information.
(2) Hanging Brackets
User Guide
Safety & Warranty Manual
3