Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection rules
-
The appliance must be connected to a 230 V, 50 Hz single-phase power
supply.
-
The appliance's power supply must be connected directly to the
network after the circuit-breaker without an intermediate switch.
-
The appliance will be connected to the mains by means of the appliance
cable via a connection box.
-
The power supply must be connected directly to the network after
the all-pole cut-off device in accordance with the installation rules.
-
If the power supply cable is damaged, it must be replaced by the
manufacturer, their after-sales service or an individual with a similar
qualification in order to avoid any danger.
Appliance wiring diagram
Switch the power off and connect the wires as shown in the wiring
diagram below:
Appliance cable
Câble de l'appareil
This appliance is fitted with a filter to
protect the heating element against dust
and dirt.
The filter can be removed for easy cleaning
with water.
To keep the appliance in perfect condition,
clean the filter once every six months, making sure you replace it.
About once a month, a message will tell you to "Clean filter". You must
then clean it.
Even when the screen displays the message indicated above, the
appliance continues to work in active mode.
If you press a button, the integrated counter is reset and the display
indicates 1 additional month of operation.
CONNECTINg ThE APPlIANCE
Live-brown
Phase=marron
Neutre=bleu
Neutral-blue
MAINTENANCE
LIVE
PHASE
NEUTRE
NEUTRAL
21
Electricity
Réseau
network
Electrique
EN
Publicité
Chapitres
Table des Matières
