Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The device you have just purchased was submitted to many tests and checks ensuring its quality.
We thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Classification of the device:
Cat C
: Complies with EU standards for this category.
IP24
: Protected against water projections.
Classe II
: Dual insulation.
Location of the device
- This device was designed to be installed in resi-
dential premises. In any other case, please call your
distributor.
- Installation must comply with the standards cur-
rently enforced in the country of use.
- Locate the device within minimum distances from
obstacles.
Do not install the device:
In a draft likely to affect its control (under
centralised mechanical ventilation, etc...).
Under a fixed mains outlet.
Inside zones 0 and 1 in bathrooms.
The heater is to be installed so that switches and other controls
cannot be touched by a person in the bath or shower.
In the UK, please refer to the IEE Regulations 601-06-01 and 601-
08-01 (BS 7671).
2) How to install the device ?
To fasten the device to the wall, observe the distances shown opposite.
This type of device must not be used in timer mode as the primary
and permanent method of heating for a room or an area.
Installing a machine at altitude causes an increase in air output temperature.
All manuals and user guides at all-guides.com
(shown on the information label)
I
NSTALLING THE DEVICE
8
Volume
3
Volume
2
Volume
1
50 cm mini
30 cm mini
1 m mini
Publicité
Table des Matières
