Husqvarna 964 99 57-03 Notice De Montage Et D'emploi page 7

0090.BOOK Seite 7 Montag, 19. April 2004 12:12 12
Spike Aerator
Practical Tips
Aerate in the straightest line possible.
Make overlapping passes to increase
density of the spike point pattern.
If the ground is extremely hard and dry, it
should be sprinkled or watered down for
one to two hours prior to use of the
aerator.
Do not aerate if the ground is too wet
(muddy).
Adding Extra Weight
Figure 2
To increase depth of spike point
penetration, weight can be added to the
tray:
Weights (concrete patio blocks are
recommended) should be secured with
rubber tie down straps.
Transporting Aerator
Figure 1
Push the Lift Handle (3) in the opposite
direction of the arrow until it ratchets
into the notch (transport position =
wheels down).
Maintenance
Before Each Use
Check all nuts and bolts for tightness,
when necessary retighten.
As Needed
If rust appears, sand lightly and coat
a ted parts with enamel paint.
Lubricate wheel bearings.
Storage
When storing for longer periods of time
(e.g. in winter):
Coat exposed, unpainted metal parts
with light oil.
Store the equipment in a dry area.
7
English
Technical Data
Length in cm 106
Width in cm 104
Height in cm 105
Weight in kg 24
Operating Width in cm 100
Warranty
In each country, warranty conditions
issued by our company or importer are
valid.
Defective equipment will be ed by us
free of charge during the warranty period
where these are the results of material
s or manufacturing. In case of
warranty claims, please contact your
dealer or nearest branch e.
GB