Safety Instructions - IFM Electronic efector 110 G15002 Notice D'utilisation

1. Safety instructions

Follow the operating instructions. Non-observance of the instructions,
operation which is not in accordance with use as prescribed below, incorrect
installation or handling can affect the safety of people and equipment.
For mounting and prescribed use of the product the notes in the operating
instructions must be carefully observed and the applicable technical
standards relevant for the application have to be considered.
In case of non-observance of notes or standards, specially when tampering
with and/or modifying the product any liability is excluded.
The unit must be installed, connected and put into operation by a qualified
electrician trained in safety technology.
After installation of the system a complete function check must be carried
out.
Disconnect the unit externally before handling it. Also disconnect any
independently supplied relay load circuits.
The design of the unit corresponds to the protection class II except for the
terminal blocks. Protection against accidental contact (finger-touch to IP20)
is only guaranteed if the terminal screw has been completely screwed in.
For installation the requirements according to EN60204-1 must be observed.
In case of malfunction of the unit please contact the manufacturer.
Tampering with the unit can seriously affect the safety of people and
equipment. This is not permitted and leads to an exclusion of liability and
warranty.
page 15