Troubleshooting - LEXIBOOK DVDP4SPZ Mode D'emploi

SYSTEM
Laser
Signal system
S / N
Dynamic range
OUTPUT
Composite video
Audio output (Analogy)
AC / DC ADAPTOR
Input
Output
The player does not turn on.
No picture on the screen.
No sound.
The player does not play the
inserted disc.
The remote control does not
operate properly or the player
does not respond properly to
the remote control.
Low quality picture.
The player's keys don't
operate properly.
DVDP4SPZ_01IM1072_15Feb_V02.indd 33

Troubleshooting

Problem
- Check the power connection.
- The battery may be empty. Recharge the battery.
- Check the battery power.
- If the player is connected to other devices (TV or
audio amplifier), check the connections.
- Make sure the connected devices operate properly.
- Check the unit's volume.
- Make sure the disc is properly inserted.
- Clean the disc.
- Make sure there are no obstacles between the
remote control and the player's remote sensor.
- Make sure to aim the remote control at the remote
sensor on the front panel of the player.
- Check the remote control's battery and replace it if
necessary.
- Make sure to use the remote control within three
metres of the remote sensor.
- Check the disc for dirt and scratches.
- Shut down the player, wait 10 seconds, and restart
the unit.
- Power surges or other electrical phenomena may
cause malfunction. Shut down the player, wait ten
seconds, and restart the unit.
Semiconductor laser wave length 650nm
PAL / NTSC
more than 70db
more than 70db
1.0V P-P 75ohm negative sync
0.5Vrms 600 ohm
AC 100V-240V~ 50 / 60Hz
DC 12V 1500mA
Solution
33
15/02/2012 11:20 AM