Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
HALFEN HLX
Application of types 1500 Loop and 2000 Loop
5
Remove the locking plate.
6
Carefully pull the load bearing
loop out of the box.
Application of types 2000 Link and 4000 Link
5
The chain link drops down out of the box and locks
automatically
5

Safety notes

≤10°
≤10°
The load bearing loop is designed for centric tension.
Assumed tension loads with an angle larger than 10° are
to be avoided.
Only use the system if you have been suffi ciently instructed
in its correct use.
Before each application check the condition of the HALFEN
HLX Lift-Box components and the concrete slab. Broken
strands in the cable, cracks in the concrete slab and signs of
corrosion are all indications of problems with the integrity of
the system.
The system must be evaluated by a qualifi ed person if there
is doubt about its integrity and its fi tness for use.
© 2020 · INST_HLX 04/20 · www.halfen.com
5
≤10°
≤10°
6
The chain link is folded back into the box after use.
Push the securing clamp up
and fi x with the locking plate
Use only rounded lifting equipment (e.g. load
hooks) with a minimum 10 mm radius.
Minimum radius
of the load hook r = 10 mm
Note: The HALFEN HLX Lift-Box is not
intended for use as a personal fall protection
unit according to EN 795.
Note: Using anchor points with insuffi cient or
missing identifi cation marking is not
allowed.
Assembly Instructions
, fold the chain link up
or with adhesive tape.
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hlx lift-box loopHlx lift-box link

Table des Matières