Octane Fitness ZERO RUNNER ZR7 Mode D'emploi page 31

FCC Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
•
To comply with FCC and Industry Canada labeling regulations, any host equipment incorporating the Octane Fitness 108581-001 module must include the FCC ID/
IC number on the host label as follows: "Contains FCC ID: 2AA4O-108581A" and Contains IC: 11442A-108581A" or similar wording that expresses the same
meaning.
• RF Exposure: This transmitter is exempt from stand-alone RF Exposure/SAR assessment and complies for portable/mobile/fixed RF exposure installation
requirements. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter, except in accordance with FCC and
Industry Canada multi-transmitter RF Exposure product procedures.
• Installation instructions: The Octane Fitness 108581-001 module is certified with a limited modular approval and shall only be installed by Octane Fitness or
authorized agents, into approved devices.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Industry Canada Notices
Octane product models ZR7 and ZR8 contain transmitter module IC: 11442A-108581A
IC Applicable Standard: CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Other Compliance Standards (Additional to those listed above or on the Declaration of Conformity)
UL 1647
FCC Part 15, Class B
IC RSS GEN and RSS-210
ASTM F2276
International Compliance Labeling
Brazil
China
Mexico
Singapore
Thailand
Motor Operated Massage and Exercise Machines
Intentional and Unintentional Radiators
Radio Standards Specification (General & Low Power License Exempt)
Standard Specification for Fitness Equipment
1049-15-9708
(01) 07899731100027
Este equipamento opera em caráter secundário, isto é, não tem direito a
proteção contra interferência prejudicial, mesmo de estações do
mesmo tipo, e não pode causar interferência a sistemas operando em
caráter primário.
Reg. Model Q37xi CMIIT ID: 2014DJ5083
This product contains an Approved Module, Model 108581-001, IFETEL No. RCPOC1014-1457.
Complies with
Complies with
IDA Standards
IDA Standards
N2667-14
N2668-14
This telecommunication equipment conforms to NTC technical requirements.
39444/SDPPI/2015
Indonesia
4532
PC-2