Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly notes, Installation and operation of the PDU metered/switched/managed
3.3
Operating conditions
The PDU may only be operated under the following operating conditions:
Operating temperature range:
Humidity range:
Protection category:
4
Assembly notes
The PDU is assembled using the brackets supplied loose as accessories. As a general rule, assembly
may be carried out either from the front or back, or from the left or right of the IT rack.
Note:
Rittal recommends always attaching the brackets to the PDU first, and then securing the
assembled unit to the inside of the enclosure, except with concealed assembly (fig. 8),
where this is not possible. This means that the distances between the brackets and hence
the mounting points inside the enclosure are pre-defined, allowing you to promptly iden-
tify any potential collisions of the PDU inside the enclosure.
Note:
Select the mounting point (position and spacing) for the two universal brackets inside the
enclosure so that they cannot collide with the clips on the rear of the PDU.
5
Installation and operation of the PDU metered/switched/managed
5.1
Operating and display elements
The operating and display elements are shown in fig. 11. The display direction and the assignment of
the four keys at the side next to the display depends on the installation direction of the PDU. The key
to fig. 11 shows the key assignment for the installation case with electrical connection of the PDU at
the bottom. If the PDU is installed with the electrical connection at the top, the assignment of keys 7
and 10 as well as 8 and 11 is reversed. The actual assignment of the keys is shown correctly on the
display.
Key to fig. 11
1
Reset button for resetting the controller
2
CAN bus connection (daisy chain) for CMC III sensors, 24 V
3
USB connection for implementing firmware updates
4
Multi-LED for status display
5
Ethernet interface RJ 45
6
Green LED to indicate the power supply
7
"Down" or "Next" key
8
"Return" key
9
Display
10
"Esc" key
11
"Up" key
Rittal PDU international/PDU UK power distribution unit
+0°C...+45°C
10%...95% relative humidity, non-condensing
IP 20 to IEC 60 529
,1 A
EN
19
Publicité
Table des Matières
