Safety Instructions - Eneo VMC-8.4LCD-CM Mode D'emploi

1. Safety Instructions

• Read these safety instructions and the operation manual first before you connect and power to the unit.
• Keep the operation manual at a safe place for later reference.
• The monitor generates only little heat. However, care has to be taken that the warm air can get out and fresh air
gets in.
• Never cover the ventilation slots to avoid overheating.
• Keep sufficient distance to other units to ensure air circulation. Overheating shortens the life time of the unit and
could set it on fire in worst case.
• If the unit is placed in closed racks it is mandatory to keep sufficient distances.
• If the monitor is brought to a warm room from a cold place allow it to warm up before you power it on.
• Protect unit and cables from entry of moisture and humidity. Never power the unit up if humidity entered but have
it checked at a qualified service station. Contamination of humidity can destroy the unit and lead to an electrical
shock.
• Operate the unit only at a temperature range of 0°C to +50°C and a humidity of max. 90%.
• Never place the monitor in direct sunlight or close to a window. Humidity and direct sunlight can cause substantial
damage.
• Never insert metallic or other parts into the ventilation slots. This could cause permanent damage to the unit.
• Never apply pressure to the LCD screen. This could cause permanent damage to the display.
• Always disconnect the unit from mains if it has to cleaned or is not used for a longer time. Unplug the cable from
the wall outlet in this case, not at the monitor.
• Make sure that the connection cables are not stressed, bent or damaged during the installation.
• The unit may only be opened by authorized personnel
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• The user of this system has to adhere to local regulations on surveillance, recording and interception of audio
signals. This is his sole responsibility to keep himself informed on these regulations.
5