Rolled And Narrow Edge; Rolled Edge; Narrow Edge - AEG 3500 Notice D'utilisation

ROLLED AND NARROW EDGE

To carry out either of the above sewing tasks proceed as follows.
(1) Refer to page 23 for special foot position setting.
(2) Turn the handwheel toward you until needles are fully raised.
(3) Open front cover and remover left needle. See page 20.
(4) Set stitch length between 1.0-2.0 mm. See page 18. Also ensure that differential control is set at
'N' position.
(5) Adjust stitch width, as shown on page 19.
(6) If not already threaded re-thread the machine.
(7) Place fabric under presser foot and start to sew.
Always test the stitch and tension settings on scrap fabric before sewing on an actual garment.
When either Rolled or Narrow hemming, we recommend you change the threads as shown on
page 25.
ALWAYS remember to re-set the special foot for normal serging after you have finished your rolled
edge procedure.

[ ROLLED EDGE ]

With a rolled edge the loops formed by the
lower looper thread should be pulled to the
underside of the fabric. This is done by setting
the tensions as shown on page 25.

[ NARROW EDGE ]

For seams on sheer or lightweight fabrics, set
tensions as shown on page 25 for a balanced
tension.
Lower looper
thread
Back
Front
Needle thread
Back
Front
( 24 )
1.0~3.0 mm
Upper looper
thread
Needle thread
1.0~3.0 mm
Upper looper
thread
Lower looper
thread