Choosing The Position Of The Remote Control; Connecting The Appliance - Zehnder Roda Twist Spa Air Mode D'emploi

EN
nOTe:
When installing your towel radiator, make
sure it is not resting on the blower or on its
infra-red receiver (see figure ③).

2.2 Choosing the position of the remote control

The remote control must under all circumstances be situated in the same room
as your towel radiator, with a maximum distance of 8m. You should preferably position
the remote control in direct line of sight, uninterrupted by any obstacle (wall, furniture,
etc.) to ensure that the infra-red signal is received correctly.
It can be secured to the wall or placed on the base provided (see chapter 3.1.1).
Before securing it in place, and after making the electrical connection of your
towel radiator, run an operating test. Make sure there are no objects likely to disrupt
signals between the remote control and the infra-red receiver on the towel radiator.

2.3 Connecting the appliance

InTrOdUCTIOn:
The technical specifications of your radiator are shown on its nameplate.
Please note these down before installing it and before requesting any after-sales
assistance.
The electricity supply must be protected by a residual current device with a
maximum of 30mA, especially when installed in a room containing a bathtub or
shower.
30
IP: protection level of your appliance against the
ingress of solid foreign bodies and water spray
Voltage and power required for installation
Appliance reference number
Class II: double insulated
OF: serial number
Manufacturer code
③