REHM BOOSTER.PRO 170 Instructions De Service page 8


The control panel is divided into the following areas:

Control lamps for overheating and operation

Button for selection of "Electrode", "Electrode with Booster Function" and "TIG" mode.
(Press this button to change between the various operating modes)

Control lamps for operating mode indication
"Electrode", "Electrode with Booster Function" and "TIG" mode.

Welding current control knob
The required welding current is selected by turning the control knob
Turning it clockwise increases the welding current.
To select the operating mode press button

lamp moves one step further.
It may be necessary to press it several times until the required mode is obtained.
7

Fig. 3.2 BOOSTER.PRO 210 control panel


. Whenever the button is pressed, the control


.