Global Industrial 292855 Manuel De L'utilisateur page 6

TROUBLESHOOTING
Problem
The Air Conditioner will
not start.
The Air Conditioner
does not cool as it
should.
Ice blocks the air flow and stops
The Air Conditioner is
freezing up.
The Remote Control is
not working.
Water is dripping
outside.
Water is dripping inside
the room.
Water collects in the Moisture removed from the air is
base pan.
Digital Display reads
"E1", "E2".
Through The Wall
Air Conditioner
Cause
The air conditioner is
unplugged.
The fuse is blown/circuit
breaker is tripped.
Power Failure
The current interrupter device
is tripped.
Airflow is restricted.
The temperature control may
not be set correctly.
The air filter is dirty.
The room may be too warm.
Cold air is escaping.
The cooling coils are frozen.
the air conditioner from cooling
the room.
The batteries are inserted
incorrectly.
The batteries may be dead.
Hot and Humid weather.
The air conditioner is not
correctly tilted outside.
draining into the base pan.
A sensor has failed.
Make sure the air conditioner plug is pushed completely into the outlet.
Check the house fuse/circuit breaker box and replace the fuse or reset
The unit will automatically re-start when power is restored.
There is a protective time delay (approx. 3 minutes) to prevent tripping
of the compressor overload. For this reason, the unit may not start
normal cooling for 3 minutes after it is turned back on.
Press the RESET button located on the power cord plug.
If the RESET button will not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.
Make sure there are no curtains, blinds, or furniture
blocking the front of the air conditioner.
Lower the set thermostat tempera ture.
Clean the filter. See the Cleaning and Care Section of the manual.
Please allow time for the room to cool down after turning on the air conditioner.
Check for open furnace registers and cold air returns.
See "Air Conditioner Freezing Up" below.
Set the MODE to HIGH FAN or HIGH COOL
and set the ther mostat to a higher temperature.
Check the position of the batteries.
Replace the batteries.
For proper water drainage, make sure the air conditioner is
slightly tilted downward from the front of the unit to the rear.
This is normal for a short period in areas with low humidity
and nor mal for a longer period in areas with high humidity.
Contact customer service.
6
Solution
the breaker.
This is normal.
User's Manual