Operating The Dishwasher - Thermador DWHD440MFM Mode D'emploi

Operating the Dishwasher

DWHD440MFM, DWHD440MFP, DWHD440MPR DWHD440MFM
NOTE: For models with hidden controls, the door must be opened before chang-
ing settings and closed after changing settings.
Start the dishwasher
1 Press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options.
3 Press [Start].
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until the dis-
play reads "0:01".
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with your
requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
3 Press [Start] to activate delay start.
To cancel delay start:
1 Press the [Delay] button until "h:00" is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see above) and press [Start] until the display
indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "b:02".
4 Press the "C" button to increase or decrease the tone "b:00" = OFF and
"b:03" = LOUDEST
5 Press [Start] to save setting and close the door.
13
B C
A