Velleman CAMCOLVC2N Mode D'emploi page 4

4.
Features
•
very small digital video recorder camera
•
recording on micro SD-card (not incl.)
•
no flash memory built in
•
only 2 operation switches
•
picture, audio and video recording
•
comes with USB cable
5.
Overview
Refer to the illustration on page 2 of this manual.
A selection switch
B mini-SD card slot
C USB port
D camera lens
E microphone
6.
Operation
•
Slide a micro SD card (not incl.) in the micro SD slot [B], see the markings on the
housing for correct way. The recorder can not work without a card.
•
Switch the camera on by moving the ON/OFF switch [F] to the ON-position (up).
The USB connection LED [G] (red) will turn on for a few seconds. Depending on the
position of the selection switch [A], either the power LED [H] turns blue or the
status LED [I] blinks green.
•
Switch the selection switch [A] in the V- position (down), to record images and
video. The power LED [H] turns blue.
•
Press the record/stop button [J] shortly to take a picture. The status LED [I]
will light up white for ±1s.
•
Press and hold the record/stop button [J] for ±3s to start video recording. The
power LED [H] starts blinking (blue). To stop recording, press the record/stop
button [J] again. The power LED [H] switches off.
Note: always stop recording first before switching off the recorder, otherwise the
data of the last recording session is lost.
•
Switch the selection switch [A] in the P- position (up), to record audio. The status
LED [I] starts blinking green.
•
Press the record/stop button [J] to start and stop recording audio. The status
LED [I] will be steady on when recording.
05/10/2010
CAMCOLVC2N
F ON/OFF switch
G USB connection LED
H power LED
I status LED
J record/stop button
4
Rev. 02
©Velleman nv