Zanussi ZRG15805WA Mode D'emploi page 23

REPLACING THE LAMP
The appliance is equipped with a
longlife LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
CAUTION! Disconnect the plug from
the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
INSTALLATION
WARNING! Refer to Safety chapters.
POSITIONING
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
3. Replace the lamp with the one that has
identical characteristics and is specifically
designed for household appliances.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
REAR SPACERS
In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.
1. Fit the spacers into the holes. Make sure that
the arrow (A) is positioned as shown in the
picture.
23