Quinny ZAPP XTRA Guide D'utilisation page 11

To Use
TM
17
Reattach Fabric Seat
17
Position seat frame and fabric facing down on a flat
surface. Slide plastic seat base into the pocket with the
fasteners and black seat bar into adjacent pocket, as
shown (Figure 17).
Flip seat and frame over.
NOTE: Tubes and channels labeled 1 through 4 must
match (Figure 17a).
Slide fabric into slot channel of the seat frame (Figure
17b).
17a 17b
While holding fabric in frame channel, slide tip of tube
labeled 1 into frame channel labeled 1. Continue to slide
tube into fabric channel as well as frame channel (Figure
17c). Repeat with tubes 2, 3 and 4.
Fasten four clips (Figure 17d).
Fit canopy fabric around canopy rod and zip canopy fabric
into place (Figure 17e).
17c 17d
4x
17e
9
4x
4x