Zibro A 20 Manuel D'utilisation page 38

D. OPERATION
Push the plug into the socket.
1
Move the ON/OFF switch to the ON setting to activate the device. The ventilator LO or
2
HI light will switch on.
Negative ions are generated and air purification commences.
Use the ventilator button (...) to set the desired speed. You can select the
3
the
Switch the device off by moving the ON/OFF switch to the OFF position.
4
E. CLEANING
Switch the air purifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a mild cleaning
agent. Wipe the device with a slightly damp cloth. Never spray the device with water.
THE HEPA FILTER
Clean the grill of the front panel with a vacuum cleaner. It is not possible to clean the HEPA
filter. It must be replaced when it becomes dirty (see section B).
Never use the device without the air filter.
4
38
(high). The appropriate light – LO (low) or HI (high) – will then switch on.
(low) or