Zibro A 20 Manuel D'utilisation page 36

Masquer les pouces Voir aussi pour A 20:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
A. WHAT YOU MUST KNOW IN ADVANCE
GENERAL
Take the following actions to obtain an optimum result.
Place the air purifier in an elevated location (e.g. on a table or cupboard) in order to
allow it to filter small particles such as smoke. Place the air purifier near or on the
ground to enable it to filter large dust particles such as pollen.
Always maintain a gap of 30 cm around the device.
SAFETY REGULATIONS
Do not connect the device with an extension cord.
Never use the device with a damaged cord or plug.
The device must be connected to the power supply with an earthed plug. Ensure that
the powercord is not entangled or rolled up.
Always switch the device off before pulling the plug out from the wall outlet. When
you pull out the plug from the socket, grip the plug to avoid damaging the cord.
It is forbidden for children to play with the device. The device may only be used by
adults.
It is dangerous and forbidden to modify the device.
It is forbidden to cover the device or to insert foreign objects into the device as a fire
or electric shock could occur.
Do not make the device wet.
Avoid using spray cans (insect spray, hairspray, etc.) in the vicinity of the air purifier.
This may damage the device and/or cause fires.
The device may not be used in humid rooms such as bathrooms.
TIPS FOR SAFE USAGE
Keep plastic bags and other packaging materials out of reach of children.
The device was developed to purify air and not for any other application.
Always contact your supplier if repair or maintenance is required.
Do not place the device in the vicinity of heat sources, materials, installations, or near
curtains, that may cause a fire hazard or in environments where explosions may occur.
Always switch the device off and remove the plug from the socket before cleaning it.
The floor must be stable and level.
B. INSTALLATION
Remove the front panel
1
of the device.
Take the filter
2
3
Put the filter back into the device, with the white side facing up.
4
36
with the aid of the fastening mechanism
out of the device and remove the packaging.
on both sides

Publicité

Table des Matières
loading

Table des Matières