Controls Layout - babymoov Babyphone High Care Notice D'utilisation

2. Operation using the (AC adapter supplied)
The transmitter can be operated on AC mains using
the supplied 6V AC adapter. Connect the output
plug of adapter to DC jack (7a) of the transmitter.
Connect the adapter to the mains. The power
supply from the battery will be cut off once the
receiver is mains-operating.
N.B.: The communication range is longest when the
transmitter is operated on AC mains.
B / Receiver
1. Operation from battery pack
The Li polymer battery pack is already installed in
the unit.
2. Recharging and operation on the base
Before using the receiver for the first time, make
sure it is turned off and recharge it on its base. The
charge indicator will show a red light. Once the
battery is fully charged (average time 3 hours) the
indicator will turn green. The receiver is then ready
to be turned on and used. If you decide to leave the
receiver on its base, when it detects that the charge
level is too low
recharging the battery.
N.B.: TO ENSURE MAXIMUM LIFE FOR YOUR
BATTERY, WAIT UNTIL IT IS COMPLETELY
DISCHARGED BEFORE RECHARGING IT.
Transmitter
1. Power ON/OFF and night light switch
2. Up/Down button
3. Mode button
4. Night light
5. Microphone
6. Power on indicator
7a. DC jack
7b. Temperature sensor
Charger
14. Charging indicator
15. Charging pins
16. DC jack
Lower Temperature Limit
Upper Temperature Limit
Baby's Room Temperature
Battery Status Indicator
14
the base will automatically start

CONTROLS LAYOUT

Receiver LCD Screen
Channel NO./
BABYPHONE HIGH CARE • Instruction Manual
1
2
Receiver
8. Power ON/OFF and vibration switch
9. Up/Down button
10. Mode button
11. LED sound level meter
12. Speaker
13. Charging contacts
Out-of-range Icon
Vibration Icon
Transmitter Battery Low Icon
Digital Code
Speaker Volume Bar Graph