Cleaning And Storage; Technical Data; Meaning Of The "Dustbin" Symbol - Clatronic DB 2988 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Ironing without steam (steam jet regulator on
1. Place the iron on its stand.
2. Turn the steam regulator (4) to
3. Always set the temperature control to „0" before connecting
the appliance to a power point, or before disconnecting it.
4. Sort out the garments according to their ironing tempera-
tures. Start with the lower temperatures. It is set with the
thermostat (1):
Synthetics, silk
• •
Wool
• • •
Cotton, linen
5. Electrical connection:
Make sure that the iron voltage (see name plate) and
the line voltage match.
Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
6. The control lamp (2) lights up. As soon as it shuts off, the
set temperature is reached. Now you can start to iron.
7. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity
regulator (4).
Steam Jet
Turn the button (5) to the steam jet symbol.
Then press the button (5) for the steam jet.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
NOTE:
To avoid excess water leaking from the soleplate do not
operate the steam burst for more than 5 seconds without
interruption.
WARNING: the steam is hot. Danger of scalding!
When ironing at low temperatures, make sure that you reduce
the quantity of steam or iron without steam. If the temperature is
too low water may leak from the soleplate.
05-DB 2988 Neu.indd 25
05-DB 2988 Neu.indd 25
)
.
low temperature
medium temperature
high temperature
no steam
Small steam volume
Large steam volume
Refi lling the water tank
Always disconnect the mains plug before refi lling water.
Set the steam control (4) to "
of the refi ll inlet (6) and carefully pour in the water. Do not
exceed the maximum line as marked on the water reservoir.
Spray Function
Turn the button (5) to the spray symbol.
In order to moisten a section to be ironed press the spray
button (5).

Cleaning and Storage

The device must never be immersed in water!
Always remove the mains lead before cleaning!
Clean the casing with a slightly damp cloth.
Clean the iron with a slightly humid cloth.
Always return the steam regulator to the „
after use and empty the water tank in order to prevent any
leaks.

Technical Data

Model: .............................................................................. DB 2988
Power supply: ............................................................230 V, 50 Hz
Power consumption: ..........................................................1600 W
Protection class: ........................................................................... Ι
Net weight: ........................................................................0,92 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment
in the domestic waste.
Please return any electrical equipment that you will no longer
use to the collection points provided for their disposal.
This helps avoid the potential effects of incorrect disposal on the
environment and human health.
This will contribute to the recycling and other forms of reutilisa-
tion of electrical and electronic equipment.
Information concerning where the equipment can be disposed of
can be obtained from your local authority.
" (no steam). Open the lid
" position
25
20.11.2008 12:53:06 Uhr
20.11.2008 12:53:06 Uhr

Publicité

Table des Matières
loading

Table des Matières