Use - DS Produkte Z 08107 Mode D'emploi

1. Unpack all parts and make sure that the product contents are complete (see chapter
"Product contents and device overview") and check for any damages from transport.
If you identify damages to the components, do not use them (!), instead contact our
customer service centre.
2. Pull any foils and stickers off of the device.
3. Clean the kettle with a damp, soft cloth. To clean the kettle you can use a small
amount of mild detergent if needed and rinse the device off with clean, warm water
afterwards. Dry it off with a soft cloth.
4. The cable is wind up on the bottom of the base. Unwind the cord completely.
5. Place the base on a dry, water and heat-resistant, even surface with suffi cient space
to fl ammable objects. Please ensure that the device is not accessible to children.
6. Insert the mains plug in a properly installed and grounded 220 – 240 V socket with
earthing contacts.
7. Fill the kettle with tap water up to the MAX mark and let it boil up (see chapter "Use").
Pour the water away afterwards. Repeat this process twice.
The kettle is now ready for use!

Use

ATTENTION!
■ Scalding hazard! Caution: Risk of emitted steam! Be careful when pouring out hot
water. Avoid coming into contact with steam emitted from the kettle. Especially, keep
hands and head away from the spout/lid.
■ Scalding hazard! When the device is in use or shortly afterwards, avoid any contact
with the hot surfaces of the device (kettle and lid)!
■ Allow the device to cool down before using the device again.
■ Do not add more water than up to the MAX mark as water may spray out of the spout
during the boiling process otherwise.
■ Fill the kettle at least up to the MIN mark with water! The device switches off auto-
matically when there is not suffi cient watter in the kettle.
■ Each time before boiling, ensure that the lid is properly closed and that the On/Off
switch is not jammed. The device only switches off automatically, when the lid is
closed and the On/Off switch is not jammed.
■ Remove the power plug from the socket, if you are not using the device,
1. Place the base on a dry, level, solid, water and heat-resistant surface and insert the
mains plug in a properly installed socket.
2. Take the kettle off the base unit. Open it by pulling the grip on the lid.
3. Fill the kettle with drinking water. Make sure that the water level is between the MIN
and MAX marks. If there is not enough water in the kettle, the device will deactivate
before completing the boiling process; if it is fi lled past the MAX mark, water may
spray out during the boiling process.
4. Close the lid. Make sure that you only touch the grip on the lid when closing the it to
prevent scalding by accident when the device has been used recently.
5. Place the kettle on the base unit.
15 EN