DS Produkte Z 08107 Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Danger of scalding! Be careful when handling hot steam, water and surfaces. Avo-
id coming into contact with the steam rising up from the pouring spout. Do not open
the lid during the boiling process.
Be particularly careful when you move the device with hot water inside it.
Always make sure that you pour out boiling water slowly and carefully without tipping
the device too quickly.
Do not move the device during the boiling process.
Danger of Electric Shock and Fire
The device should only be connected to a properly installed plug socket with safety
contacts. The plug socket must also be readily accessible after connection so that
the connection to the mains can quickly be isolated. The mains voltage must match
the technical data of the device. Only use suitable extension cables whose technical
data is the same as that of the device.
Never immerse the kettle, base station, mains cable or plug in water or other liquids
and ensure that they cannot fall into water or become wet.
Should the base station fall into water, switch off the power supply immediately. Do
not attempt to pull it out of the water while it is still connected to the mains power!
Do not use the device if it malfunctions, has fallen down or in water. Before use it
should be checked in a specialist workshop.
Never touch the kettle, base station, mains cable or plug with wet hands when these
components are connected to the mains power.
Take the kettle off the base station to fi ll it, pour water or clean it.
Switch the device off and pull the mains plug out of the plug socket when a fault
occurs during operation or before a thunderstorm.
Always pull the plug and never the mains cable.
Use the device only in closed rooms.
Do not use the device in rooms containing easily ignitable dust or poisonous and
explosive fumes.
Do not operate the device in a very damp environment or in the vicinity of combus-
tible material.
Always check the device for damage before putting it into operation. Only use it if the
kettle, base station, mains cable and plug have no signs of damage!
Avoiding Damage to Material, Property and the Device
Always place the base station on a dry, level, fi rm and heat-resistant surface.
Lay the cable in such a way that it does not present a trip hazard. Do not allow the
cable to hang over the edge of tables or kitchen counters. Others may become
caught and pull the device down.
Make sure that the mains cable is not squashed, bent or laid over sharp edges and
does not come into contact with hot surfaces.
Do not use any other accessories.
Do not operate the device without water in it or with less water than is required to
reach the Min marking. If this does happen, the device switches off automatically.
13
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bl08

Table des Matières