Backlight; Battery Replacement - TFA Change Mode D'emploi

TFA_No. 60.2544_anl_02_18 26.02.2018
CHANGE – Radio-controlled alarm clock
• You can now set the snooze interval.
• 05 (default) or the last adjusted snooze interval appear on the display.
• Set the desired time duration (5 to 60 minutes) by turning the dial.
• Press the dial to confirm.
7.3.2 Activate and deactivate the alarm
• To activate or deactivate the alarm function, press and hold the SNOOZE/LIGHT sensor button for 3 seconds.
The alarm symbol appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached.
• Press the dial and the alarm will stop.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes
and it will be reactivated at the same set time on the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE/LIGHT sensor button briefly and the snooze function is activated.
• Once the snooze function is activated, SNOOZE will be flashing on the display.
• The alarm will be interrupted for 5 minutes (default).
9:59 Uhr Seite 16
– 30 –
CHANGE – Radio-controlled alarm clock

7.4 Backlight

• Press the SNOOZE/LIGHT sensor button.
• The backlight turns on for 5 seconds.
8. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries if the device will not be used for an extended period of time.
• Keep the device in a dry place.

8.1 Battery replacement

• Change the batteries when the battery symbol appears on the display.
• Open the battery compartment and insert two new AA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.
– 31 –