Mounting - eQ-3 MAX! Eco Mode D'emploi

You can either use screws or adhesive strips to mount the
MAX! Eco Switch to a wall in the frame supplied or integrate
it into an existing switch (see Section 10 for more detailed
information about compatible switches).
Adhesive strip mounting:
The sur face on which you are mounting the
pushbutton must be clean and dry.
At tach the adhesive strips to the rear of the
•
mounting plate.
Remove the protective film from the adhesive strips.
•
Press the rear of the mounting plate to the wall where
•
the MAX! Eco Switch will subsequently be attached. The
arrow on the mounting plate should point upwards.
Attach the frame to the mounting plate.
•
Attach the electronic unit to the frame, on the mounting
•
plate. Make sure that the clips on the mounting plate
latch into the openings on the electronic unit.
Screw mounting:
Position the mounting plate on the wall. Make sure that
•
the arrow on the mounting plate is pointing upwards.
Use a pen to mark the positions of the bore holes (a) in
•
the mounting plate on the wall.
Use the screws and plugs supplied to fasten the plate
•
to the wall.
Next, attach the frame to the mounting plate.
•
Attach the pushbutton. Make sure that the clips on
•
the mounting plate latch into the openings on the
electronic unit.
16

6. Mounting