Maintenance; Decommissioning; Troubleshooting - Schneider Airsystems KNG 40/50 SYS Notice D'utilisation D'origine

GB
KLG / KNG / SNG / RNG / PNG
Load fasteners:
1. Lift the catch lever (item 03) (if avail-
able) and open the magazine slide
(item 05) (Fig. 2a).
2. Load the correct fasteners into the bot-
tom / side / top-loading magazine
(item 04) (Fig. 3a).
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
3. Close the magazine slide (item 05) and
allow the catch lever (item 03) (if avail-
able) to engage.
Contact trigger (if available, see Techni-
cal data):
Contact trigger function when trigger lever
(item 02) pulled. Functions when tool is
pressurised.
or
Contact trigger function deactivated when
reversing lever actuated (item 13) (fig. 5a).
Tool is then depressurised.
Compressed air connection:
1. Install an upstream maintenance unit
with filter pressure reducer and mist oil-
er.
2. Press the quick-action coupling of the air
hose onto the plug nipple (item 01)
(Figure 1a).
Operation:
1. If available:
(item 10)
2. Set the required pressure
3. If available: adjust the depth setting
(item 08) (Fig. 4a).

2.7 Troubleshooting

Problem
A Device does
function
B Compressed
escaping from the
opening on
cover
II/8
release the interlock
Cause
not Trigger lever (item 02)
secured with interlock
(item 10)
Working pressure (flow
pressure) too low
air O-ring or seal dam-
aged or dirty
the
4. Place the trigger safety device (item 06)
or guide plate (item 07) onto the work-
piece and apply pressure firmly.
5. Press the trigger lever (item 02).
6. If available: contact trigger actuated
when trigger lever (item 02) pulled and
trigger safety device (item 06) placed on
the workpiece.
After use:
1. If available:
Secure the interlock (item 10).
2. Disconnect the quick-action coupling
from the plug
(Figure 1b).
3. Empty the magazine (item 04).
4. Clean the device dry with compressed
air.
5. Store the device in a secure location.

2.5 Maintenance

 Regular lubrication is required!
Apply oil via a maintenance unit with a mist

oiler.
Without mist oiler: oil daily by hand via the

plug nipple (item 01).
In the event of longer interruptions in op-

eration, also lubricate
nipple (item 01).

2.6 Decommissioning

Storage: Clean, dry, dust-free, not below
5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.
Remedy
Unlock the trigger

(Fig. 4a)
Increase working pressure (flow pressure)

Observe maximum working pressure
Contact Schneider Druckluft GmbH or an

authorised service partner.
nipple (item 01)
via the plug
lever (item 02)
*
****