Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FUTURA
placed on a minimum 12 cm thick slab made of stone or concrete. The base must extend at least 50 cm at the front and at least
30 cm at the sides, in addition to the opening of the loading door (see
d) no flammable components (e.g. wall units) must be present above the product.
The Product must always operate exclusively with the ash drawer inserted. The solid combustion residues (ash) must be collected in a
sealed, fire resistant container. The Product must never be on in the presence of gaseous emissions or vapours (for example glue for
linoleum, petrol etc.). Never deposit flammable materials near the Product.
During combustion, thermal energy is released which leads to considerable heating of the surfaces, doors, handles, controls, glass parts,
the flue gas pipe and possibly the front part of the appliance. Avoid contact with these elements unless using suitable protective
clothing or accessories (heat resistant gloves, control devices).
Ensure children are aware of these dangers and keep them away from the furnace when it is on.
When using the wrong fuel or one which is too damp, due to deposits present in the flue, a flue fire is possible.
5.1.
IN A EMERGENCY
If there is a fire in the flue connection :
a) Close the loading door and the ash drawer door
b) Close the comburent air registers
c) Use carbon dioxide ( CO
d) Request the immediate intervention of the Fire Brigade
DO NOT PUT OUT THE FIRE WITH WATER.
When the flue stops burning, have it checked by a specialist to identify any cracks or permeable points.
6. TECHNICAL DESCRIPTION
Definition: Product in compliance with EN 13240.
La Nordica chimney stoves are suitable for heating living spaces for some periods. Fuel used in MANUAL mode: logs of wood or pressed
wood briquettes; in AUTOMATIC MODE: ONLY pressed wood briquettes.
IMPORTANT: The simultaneous use of both types of fuel mentioned above is not envisioned in AUTOMATIC mode!
The following chapters explain how to switch the stove for use in MANUAL and AUTOMATIC modes. The appliance works as an
intermittent operating appliance.
The stove is made of sheets in galvanized and painted steel, of cast iron (grate and grate holder of the hearth, exhaust pipe) of majolica
tiles. The hearth is totally sheathed with cast-iron single sheets and refractory material (IRONKER®). Inside there are a easy extractable
thick flat grate and its holder. The combustion chamber is hermetic welded and is sheathed with a painted steel carter.
The inside smoke plate, reflects the fire radiation and increases the internal temperature of the combustion chamber. This process together
with the exhaust gases flows, makes optimal the combustion and improves the efficiency.
The one-piece ceramic glass of the door (resistant up to 700 °C) allows a wonderful view on the burning flames. Furthermore, it is thus
avoided the output of sparks and smoke. Below the hearth grate there is an extractable ash drawer,
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of the stove, the
heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1A - PRIMARY AIR register (left lever)
Below the hearth door, on the front left side, there is the primary air register, in the style of lever
With this air register, it is adjusted the passage of primary air into the low part of the stove and through particular channels flows in the
fuel direction. The primary air is necessary for the combustion process during lighting. The ash drawer must be regularly emptied, so
that the ash does not obstruct the entry of the primary air for the combustion. In order to open the air flow, the bar must be completely
pulled out.
During wood combustion, the register of primary air must be opened only for a while, because otherwise the wood burns too fast and
the stove may overheat (see chapter NORMAL OPERATION).
2A - SECONDARY AIR register (right lever)
Below the hearth door, on the right front side there is the secondary air register
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double combustion and keeping at
the same time the glass clean (with open register).
When the bar is pushed to the back the passage of the secondary is completely open (see chapter NORMAL OPERATION).
Through this register it is possible to adjust the power of the stove. Leaving it slightly open, according to the flue of the chimney, it is
possible to keep the glass clean.
The adjustment of the registers necessary to reach the rated calorific yield is the following one:
OPERATION
MANUAL mode
AUTOMATIC mode
8291003 - IT - EN - DE - FR
powder ) extinguishers to put out the fire
2
Fuel
Logs of wood
Pressed wood
BRIQUETTES
Picture 4 at page 64
(Picture 6 at page
PRIMARY air
SECONDARY air
CLOSED
OPEN
- B).
(Picture 12 at page 67
(Picture 6 at page
65).
TERTIARY AIR
OPEN
Pre-adjusted
OPEN
Pre-adjusted
A).
65)
23
Publicité
Table des Matières
