Mounting - werma 728 55 Série Mode D'emploi

Type Voltage / Frequency
729 x20 60 (115 VAC 50/60 Hz -
230 VAC 50 Hz)
729 150 55
729 350 55
729 250 55
729 450 55
729 550 55
729 x50 60 (115 VAC 50/60 Hz -
230 VAC 50 Hz)
729 160 55
729 360 55
729 260 55
729 460 55
729 560 55
729 x60 60 (115 VAC 50/60 Hz -
230 VAC 50 Hz)
7

Mounting

For dimensions and mounting see "Zeichnungen / Drawings / Dessins" page 18
et seq.
If required, a wire guard can be screwed on (accessory).
(see fig. 7 page 20)
7.1 Cable entry
The beacon connection area is provided with 2 M20x1,5 lead-in holes, one
cable entry M20x1,5 und 1 plug M20x1,5 must be screwed into place.
The temperature specifications for the cable entry and plugs must be
observed!
Notes:
• Check the cable entry clamping area against the diameter of the cable to
be brought in, min. degree of protection IP66.
• Firmly tighten the cable entry itself and the cable entry pressure screw for
sealing.
• The unused opening must be closed with certified plugs.
• Following installation IP66 must be guaranteed.
>>IP protection type is part of the explosion protection measures<<
• Suitable certified screws and plugs must be employed for the correspond-
ing Ex application.
Observe mounting and safety instructions:
• Operating temperature
• Possible for zones 1 and 2 as well as zones 21 and 22
• Damage to the signal beacon endangers the explosion protection!
230 VAC
24 VDC (0 Hz)
230 VAC
24V DC (0 Hz)
230 VAC
Lamp Current consumption
0.07 A (115 V~)
LED
0.15 A (230 V~)
<0.14 A
LED
<0.09 A
0.07 A (115 V~) 0.14
LED
A (230 V~)
<0.24 A
LED
<0.15 A
0.07 A (115 V~) 0.14
LED
A (230 V~)
Power T class Surface
consump- temp.
tion.
1.1 W
(115 V)
T5
3.6 W
(230 V)
1 W
T6 80 °C
0.7 W
1.3 W
(115 V)
T5 95 °C
3.8 W
(230 V)
2.8 W
T6 80 °C
1.9 W
1.3 W
(115V)
T5
3.8 W
(230V)
95°C
95°C
11