Package Contents - Aspira ASPIRVELO AIR ECOCOMFORT Série Manuel D'utilisation Et D'installation

• If repair is necessary contact the Manufacturer and ask for only original spare parts.
• If the above action is not carried out, the safety of the appliance could be jeopardized.
• Should it be decided not to use this appliance any longer, it should be removed from the electrical supply and
rendered inoperative, then disposed of in the normal manner. It is also recommended to make harmless those
parts of the appliance which could be harmful, especially to children who might play with the disused appliance.
• The installation must conform to the requirements of the latest issue of the I.E.E. wiring regulations.
• This appliance has been constructed to comply with the requirements of the following European Directives
CE2006/95; CE2004/108.
• The set is workmanlike manufactured. A correct use and a regular maintenance guarantee life and reliability
of all electrical and mechanical parts.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or lack
of experience and knowledge unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should bensure that they do not play with the
appliance.
• Installation must be carried out as detailed in these instructions. The user is warned that incorrect
installation could cause harm to persons or animals or damage to property. The Manufacturer cannot be
held responsible in such cases.
• The apparatus is double insulated (Class II) and does not require earthing.
• Check that the current carrying capacity of the mains wiring and socket are adequate for the maximum rating
of the device shown on the rating label. In case of doubt consult a suitably qualified person.
• When installing, it is necessary to use a double pole switch with a contact separation of 3 mm or more.
• Do not leave the appliance plugged if unnecessary. Switch off the main switch of the appliance when the
appliance is not in use.
• Do not obstruct the air inlet or outlet grilles.
• In conformity with prevention and safety laws in force, when installation of exhaust fan is completed, make sure
that it is not at all possible to reach the motion parts from the inlet side. On the contrary it is necessary to mount
the special protection shutter (cod. AP0885, AP0893).
• If there is already a combustion fuel appliance in the room, it is essential to ensure that the air supply to the
room is adequate for the correct functionning of both the combustion appliance and the fan.
• Do not install the fan in the same duct where gas appliance fume is conveyed.
• The appliance must discharge into a single exhaust pipe or directly outside the building.
• The system can be either wall-mounted or ceiling-mounted.
4.

PACKAGE CONTENTS

7
1
12
3
2 4
1. Fan unit
2. Heat exchanger with extraction
handle
3. Telescopic tube
4. Control unit
5. Grid inside/outside
5
6. Power supply 12Vcc
7. Flow rectifier
Instruction sheet
6
E N G L I S H
ECOCOMFORT Series