Maintain The Producer Iii Autoloader; Maintenance Schedule; Aligning The Printer; Aligning The Everest Printer - Rimage Producer 7100 Manuel D'utilisation

Maintain the Producer III autoloader

Maintenance schedule

Task
Clean the autoloader
Align the printer

Aligning the printer

Aligning the Everest printer

To align your Everest printer, use the following instructions.
Required tools:
•
T25 Torx screwdriver
•
5/32" Allen wrench
1. To power on the Producer III autoloader, press the power switch.
2. Wait for the autoloader to complete initialization.
Tip: The Everest printer takes one to two minutes to complete initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the
top of the column.
b. To place a disc in the lift arm, press
the disc up into the lift arm while
pressing the disc release button.
c. To open the printer tray, press the
printer button.
4. Open the top access cover.
Tip: Look down through the top
opening to observe printer
alignment.
110867_A
Maintain the Producer III autoloader
Frequency
Once a week. Remove dust from the autoloader and
surrounding work area.
Upon installation or if the discs are not picked correctly from
the printer tray. Refer to the procedures below for more
information.
Top Access Cover
Gripper
Disc Release Button
Lift
Arm
9