Sanitation - Laerdal Resusci Anne Mode D'emploi

Resusci Anne DFU 6736C.qxd
Resusci Anne
We recommend you provide an individual Manikin Face to each student. This eliminates the need for decontamination between students.
All students can also use one face permanently installed on the manikin and disinfect the face between each student's use.
Using Resusci Manikin Faces on an individual basis
Each student in the class should install and remove his
or her manikin face.
1
To remove
1 Detach manikin face from retainers at each ear.
2 Lift manikin face off valve coupling.
To remove the airway
Having removed face, remove neck
skin from chin.
Connect expiration and inspiration
tubes.
Push expiration tube into retainer
in manikin's side until end
protrudes about 2-3 cm (1").
Caution
Make sure that the SkillReporter/manikin has been turned off /
the SkillGuide is unplugged from manikin:
- when airway is changed, or
- when internal service is carried out.
8
04-12-06 12:49 Page 8
S A N I TAT I O N
Sanitation of Manikin Faces, see separate sheet.
2
Airway is designed for disposal after each class.
1
Pull to remove jaw.
5
Slide tubing through slot in lung
plate, to detach airway assembly.
Discard used airway.
3
Push inspiration tube through neck
and click airway connector into
its holder.
1
To install
1 Turn manikin face inside out and push face coupling into
airway valve.
2 Push face coupling into airway connector until fully seated.
3 Fasten manikin face to retainers at each ear.
2 3
Detach airway connector and pull
inspiration tube through the neck.
To install the airway
6
1
Slide tubing through slot in lung plate,
with lung on top.
4
5
Install jaw by sliding its forked
portions over steering pins
in the inner head.
To reinstall chest cover:
Make sure the switch cover for the hand
position impulse unit (a) is on top of the
protruding end of the slider for the
ventilation-compression impulse unit (b).
Button the chest cover onto torso
2 3
Pull expiration tube from its
retainer in the manikin's side.
2
Push on lung connector until fully
seated in lung plate.
Make sure the ventilation slider can
move freely.
6
Fold neck skin over jaw,
and install face.
a
b