Quick Handling Mode ・ Dead Zone Adjustment ・ Linearity Adjustment Reset All; Assign Mode; How To Adjust - HORI Apex Manuel D'utilisation

■ Quick Handling Mode ・ Dead Zone Adjustment ・ Linearity Adjustment Reset All
To simultaneously reset all of the following : Quick Handling Mode ・ Dead Zone Adjustment ・ Linearity Adjustment.
①
②
③
When Quick Handling Mode is canceled, steering wheel input value will default to 270°.
Dead zone and linearity default values are set to "4".
* If you do not perform step ② after ①, the ASSIGN LED will turn off after four seconds and
button assignment mode will automatically end.
■

Assign Mode

You can remap the function of buttons using this feature.
Programmable Buttons
L2 / R2 / L paddle / R paddle / L pedal / R pedal

How to adjust

①
②
L2 / R2 / L paddle / R paddle /
L pedal / R pedal
③
○ / × / △ / □ /
L1 / L2 / L3 /
R1 / R2 / R3 /
L paddle / R paddle /
L pedal / R pedal
3
sec
Assignable Functions
○ / × / △ / □ / L1 / L2 / L3 / R1 / R2 / R3 / L paddle / R paddle / L pedal / R pedal
Left stick (Right / Down / Left / Up) / Right stick (Right / Down / Left / Up)
3
sec
or
Left stick /
Right stick
* Press the direction
(Right, Down, Left or Up) to
assign the desired function.
* For step 3, to assign a specific direction input of the Left Analog Stick to a button,
set the Directional buttons toggle switch (DP/LS/RS) to [LS] and press the D-Pad
in the direction you want to assign. For Right Analog Stick, set to [RS].
"LS" for Left stick
Program LED (Right)
will turn on.
Program LED (Left)
will turn off.
(The ASSIGN LED will light red when assigning buttons.)
Program LED (Right)
will turn on.
Program LED (Right)
will flash.
Program LED (Left)
will turn on.
or
"RS" for Right stick
Program LED (Right)
will turn off.
Program LED (Right)
will turn off.
7