Air Supply And Connections - Haussmann PNT240-SG Manuel De L'utilisateur

GENERAL SAFETY INSTRUCTIONS
SERVICE
Tool service must be performed only by qualified repair personnel.

When servicing a tool, use only identical replacement parts. Use only authorized

parts.
Use only the lubricants supplied with the tool and specified by the manufacturer.


AIR SUPPLY AND CONNECTIONS

The air supply connection must not hold pressure when air supply is disconnected.

If an incorrect fitting is used, the tool can remain charged with air after
disconnecting and thus will be able to work even after the air line is disconnected,
possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and

combustible gases, as a air source. Use filtered, lubricated, regulated compressed
air only. Use of a reactive gas instead of compressed air may cause the tool to
explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 150 PSI. The
tool could explode, which will cause death or serious personal injury.
Always disconnect air supply from tool:

a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
16
PNT240-SG