Print / Pair Mode Calculation Switch; Store / Recall Memory Key - Canon CP1013D II Mode D'emploi

<PRINTOUT OF ITEM COUNT>
When the PRINT switch is turned "ON", and the "ITEM" switch is
at the "n+" or "n+/–" position, the number of items recorded by
the counter can print up to three digits on the left-hand side of the
paper by pressing either the
and
<AVERAGE CALCULATION>
Set the switch to "AVE", after pressing the
the calculator prints the average below the total. The number to
the left of the total shows the number of entries in the calculation.

PRINT / PAIR MODE CALCULATION SWITCH

PRINT OFF:
Entries and result will appear on the display but will not be
printed out.
PRINT ON:
Entries and result will appear on the display and will be
printed out.
PAIR MODE CALCULATION:
Set the switch to "PAIR", enables you to total two kinds of
corresponding data at the same time.
In the Pair mode, the first number entered and every
alternate number entered after that is accumulated in the
first register.
Correspondingly, the second number and every alternate
number entered after that is accumulated in the second
register.
Press
accumulated in both registers and obtain their Sub-total.
Press
accumulated in both registers and obtain their total. This
function can only be used for addition calculations.
Multiplication and division are not possible.
All entries and results in the first register and printed in
black and those in the second register are printed in red.

STORE / RECALL MEMORY KEY

Pressing the
current store memory contents and stores the entered number
in the store memory. Pressing the
preceded by any key recalls the current store memory
contents. Entering zero clears the store memory contents.
key or key for memory item count.
key to simultaneously print out entries
key to simultaneously print out entries
key after entering the number clears the
key or the
to total the entries,
key without being
3
key for item count