Loewe Audiodesign 525 Mode D'emploi page 14

Start-up and settings
Before beginning with the start-up and settings, make sure that all the cables
are connected correctly.
Switching the subwoofer on/off
Use the mains switch to switch the subwoofer to the ON position.
11
Mode with Loewe TV sets
If the subwoofer is connected as described on side 12 or 13 and the Auto
Mode switch is in the OFF position, you no longer need to switch the
10
time it is switched on and off automatically with the Loewe TV set.
Automatic mode with other audio sources
If the Auto Mode switch is in the ON position and audio signals are
10
present at the cinch sockets Line IN Front Left/Center/Front Right, then the
subwoofer switches itself on automatically. If no audio signals are present at
these sockets for a duration of 10 minutes, then the subwoofer switches itself
off automatically.
➠
The subwoofer can switch itself on automatically if any interfering signals are
present on the audio cables. In this case, switch the unit off at the mains
➠
The subwoofer can switch itself off automatically during long, very quiet
Settings on the Loewe TV set
Make the necessary settings to your subwoofer as described in your Loewe TV
set's operating instructions in the "Operating additional devices" / "External
devices" chapters.
- 14
Setting the equalizer
Using the Equalizer knob
50 Hz) for bass reproduction to be raised or lowered.
• If the subwoofer is near the corner of the room, turn the Equalizer knob
more in the -3 dB direction.
• If the subwoofer is near a wall, then turn the Equalizer knob more to the
middle position.
• If the subwoofer is freely positioned in the room, turn the Equalizer knob
more in the +3 dB direction.
Bass intensity
Using the Bass Intensity controller
suit you.
Setting the crossover frequency
Crossover Frequency
for bass reproduction between 50 Hz and 250 Hz depending on which speakers
you have connected.
As described on side 12 or 13, for Loewe audio systems the knob should
.
11
be set to 250 Hz because the crossover frequency is set to this in the Loewe
audio sources (TV set).
Wireless
Set the wireless switch
subwoofer to an audio source via a cable, otherwise you will not hear any
sound.
Move the Wireless switch to the ON position if you wish to connect the
6
subwoofer wirelessly to a compatible audio source.
Activate Coupling mode, as described in the instruction manual of the relevant
audio source. Use the Wireless Pairing
sharp object. A message appears on the display of the audio source if the reg-
istration was successful. If the registration was not successful, please try again
and reduce the distance of the subwoofer to the audio source.
Cover on the subwoofer
After you have made the settings described in "Start-up and settings", mount
the cover on the rear of the subwoofer.
you can set the lowest frequency ranges (20 Hz -
5
you can set the basic bass volume to
3
knob to set the crossover frequency
4
to the OFF position once you have attached the
6
button on the subwoofer using a
7
5
5