Loewe Audiodesign 525 Mode D'emploi page 12

Connection
Cabling for Loewe TV set (SL2xx) - Loewe subwoofer - loudspeaker
➠
The TV set must be equipped with a Digital Audiolink.
and the Converter Digital Audiolink / Audiolink (included with the Loewe
Subwoofer 525, order no. 69211T/U/W30) or you can connect it wirelessly to
a compatible audio source via the Module Wireless AudioLink which can be
If you wish to connect the subwoofer using the network cable, connect the
Converter Digital Audiolink / Audiolink to the 25-pin Audiolink socket
of the subwoofer. Use the network cable to connect the Digital Audiolink of
the TV set to the socket of the Converter Digital Audiolink / Audiolink.
Front
left
- 12
(Cat. 5e or higher)
Converter Digital Audiolink / Audiolink
Front
right
Center
Rear Rear
left right
Connect the speaker cable to the speaker according to the appropriate instal-
lation instructions. One of the two wires of the speaker cables is usual marked
black. Connect this black marked cable to the black screw terminal on the
subwoofer
8
on the speaker. Turn the screw connection of the respective terminal on the
subwoofer anticlockwise about 5 turns. Feed the wire end into the screw termi-
nal (top right-hand side) and close the screw terminal by turning it clockwise.
Connect the unmarked wires to the red terminals.
2
Use the mains cable supplied to connect the 220-240 V socket
woofer to a 220-240V 50/60 Hz socket.
Loewe Subwoofer
of the sub-
9
Mains cable
Network cable
Loewe TV set (SL2xx)