Converter Features; Before Using Your Power Converter - Schumacher Electric SI1479 Manuel D'utilisation

1.15 Do not place the converter in direct sunlight. The ideal air temperature for
operation is between 14 and 104 °F ( - 10˚- 40 ˚C).
1.16 Only connect the power converter to a 12V accessory outlet or 12V battery.
1.17 Do not attempt to connect the converter to any other power source, including an AC
power source. Connecting to a 6V or 16V battery will cause damage to the converter.
1.18 Do not modify the AC or USB receptacle in any way.
1.19 Do not try extending or otherwise changing the 12V power cord attached to your
converter.
1.20 Incorrect operation of your converter may result in damage and personal injury.
1.21 This device does not include an internal Ground Fault Circuit Interrupter (GFCI).
1.22 Use only 25A fuses.
1.23 Restrictions on Use: This converter may not be used with life support devices
or systems. Failure of this converter can reasonably be expected to cause failure
of that life support device or system, or to affect the safety or effectiveness of that
device or system.

2. CONVERTER FEATURES

1. LED indicator light:
Green = Power ON
Red = Overload, Over temperature, Over voltage, Under voltage
2. Standard electrical 120V AC outlet
3. 12-Volt power plug
4. USB port
5. Low-battery protection

3. BEFORE USING YOUR POWER CONVERTER

When you turn on a device or a tool that runs on a motor, the device goes through 2 stages:
1. Start Up – Requiring an initial surge of power (commonly known as the
"starting" or "peak" load).
2. Continuous Operation – Power consumption drops (commonly known as the
"continuous load").
The wattage (WATTS) or amperes (AMPS) can normally be found stamped or
printed on most devices and equipment, or in the user's manual. Otherwise,
contact the manufacturer to find out whether the device you want to use is
compatible with a modified sine wave.
• 6 •