Applications; Operation - Homelite UT44171 Manuel D'utilisation

WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not allow familiarity with product to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.

APPLICATIONS

You may use this product for the purpose listed below:
 Trimming and shaping hedges and shrubbery
CHARGING THE SHRUbbER
See Figure 2.
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
it overnight prior to use. After each use, charge for at least
8 hours.
ASSEMbLy
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

OPERATION

To charge:
 Stop the motor.
 Install padlock (not included) or lock-out pin into switch
trigger hole. Keep both hands away from switch.
 Insert charger plug into input jack making sure they are
properly connected.
 Charger can be used with normal household voltage
of 120 volts, AC only, 60 Hz.
 Connect charger to power supply.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
LOCK-OUT bUTTON
See Figure 3.
The lock-out button reduces the possibility of accidental
starting. It is located on the handle above the switch trigger
and must be depressed before you pull the switch trigger. The
lock-out button resets each time the trigger is released.
SWITCH TRIGGER
See Figure 3.
To prevent unauthorized use of the shrubber, disconnect it
from the power supply and lock the switch in the off posi-
tion. To lock the switch, install a padlock (not included) or the
lock-out pin through the hole in the switch trigger. A padlock
with a long shackle up to 9/32 in. diameter may be used.
When a padlock is installed and locked or the lock-out pin
is installed, the switch is inoperable. Store the padlock key
in another location.
Page 9 — English