Makita BUB360 Manuel D'instruction page 5

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the long nozzle
1
2
3
011051
To install the long nozzle, push in onto the blower outlet
of the tool all the way.
1
011055
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
011057
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.
1. Hook
2. Button
3. Long nozzle
1. Button
1
1. Hanger
1
OPERATION
Blowing
011054
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly
When blowing around a building, a big stone or a vehicle,
direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Cleaning
011053
From time to time, wipe off the outside of the tool using a
cloth dampened in soapy water.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
5