Panasonic TY-CE103PS10 Manuel D'installation page 14

Precautions with regard to setting up
Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to light
or heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is extremely
soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a dry cloth. Do not
use cleaners such as benzene, thinner or furniture wax because they may cause paint peeling. (If using
a chemical wiping cloth, follow any precautions included.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the ceiling-hanging
bracket.
4) Take care during installation as shocks can cause 'panel cracks' to the plasma dispaly unit.
Points to note during installation
Installation and removal work must be carried out only by a qualified technician.
If the unit is installed or removed improperly, the display may fall down and personal injury may result.
This equipment is a ceiling unit to suspend the Plasma Display from a ceiling structure for viewing
purposes. The ceiling unit must not be installed in any locations other than ceiling structures with sufficient
strength.
In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in any
of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
When installing this ceiling unit, use a fixing method appropriate to the type of ceiling.
When installing the ceiling unit to a ceiling structure, use structural components appropriate to the material
of the structure, and an installation method.
Provide adequate ventilation so that the temperature around the display does not rise above 40 °C (104
°F). If there is insufficient movement of the air inside display, heat may build up inside the display, and fire
may result.
Spread a soft blanket or cloth over the floor so that the Plasma Display and floor will not be marked or
scratched during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
Take sufficient care to ensure safety around you when performing the assembly and installation work or
while moving about during the course of the work.
Do not use any components other than the packaged ones.
Do not install the Plasma Display underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise,
the cabinet may be bent or damaged by high heat.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING
14