Installation Of The Motor; Installation Of The Control Panel; Electrical Wiring - Procopi Delta AQUAMAT 3001 Notice De Montage Et De Mise En Service

Position the axle such that the groove is facing upwards.
Mount the motor by sliding the pin into the groove on the hollow shaft. Push all the way in. If the
motor does not slide smoothly, make sure that the pin is correctly positioned. Install the U-shaped
pin, making sure that it protrudes from the bottom of the lower mounting flange.
Connection box
Use a Ø 8 drill bit to bore a hole in the wall above the AQUAMAT motor and mount the connection
box.

INSTALLATION OF THE CONTROL PANEL

Install the control panel in a location protected from the elements and humidity. The control panel
must absolutely not be installed in the motor pit.
Attach the control panel support frame to the wall first, then attach the control panel itself. Fix in
position using the screw provided.
CONTROL PANEL POWER SUPPLY
In accordance with the French standard, C15-100, a 30 mA differential circuit breaker must be
installed at the head of the power line.
Connect the 220 V power supply to the N, Ph, T (neutral, live, earth) terminals, located at the
bottom right-hand side of the control panel. Clip the ferrite ring around the power cable.
KEY OPERATING SWITCH
Connection:
- Terminal "0" of the control panel to the upper right side of the key operating switch with the
shunt already in place.
- Terminal "1" of the control panel to the bottom right side of the key operating switch.
- Terminal "2" of the control panel to the bottom left side of the key operating switch.
Use a 3 x 1.5² cable.
CONNECTING THE AQUAMAT 3001 MOTOR
Connect the "+" and "-" terminals of the control panel to the "+" and "-" terminals of the
'AQUAMAT 3001 motor. If the distance between the control panel and motor is less than 40m
use a 2 x 4 2 cable, for distances greater than 40m use a 2 x 6
CONNECTING THE END OF TRAVEL SENSORS
Connect the terminals "A", "T" and "C" in the control panel to the terminals "A", "T" and "C" in the
AQUAMAT 3001 connection box.
Use only a shielded cable to make this connection, the metallic braid should be connected
to the "B" terminals in the control panel and the AQUAMAT•3001 connection box.
WIRING IN THE MOTOR CONNECTION BOX
Once the AQUAMAT 3001 motor is wired in, plug the two quick fit connectors of the connection
box into the motor. Connectors are "fool proofed" to prevent confusion. Tighten the quick fit
connector nuts by hand.
INSTALLATION•OF•THE•MOTOR

ELECTRICAL WIRING

2 cable.
12/16
2014/05 - Indice de révision : D - code : 0034401