Safety Instructions; Preparation Prior To Installation - Procopi Delta AQUAMAT 3001 Notice De Montage Et De Mise En Service

The AQUAMAT 3001 is designed for use with DELTA automatic covers with a slat apron surface
2
area less than 98m
In accordance with the French standard, C15-100, a 30 mA differential circuit breaker must be
installed at the head of the line.
The motor system comprises the AQUAMAT 3001 motor, its control panel and the PLC
(Programmable Logic Controller).
The motor should only be operated with the AQUAMAT control panel. Operation of the motor
without the AQUAMAT control panel is dangerous and therefore not recommended.
Due care and vigilance should be exercised when opening and closing the pool using the
AQUAMAT motor. Upon encountering the slightest problem while rolling the cover up or out, stop
it (position 0 on the key switch) and contact a technician.

PREPARATION PRIOR TO INSTALLATION

- The motor can only be installed on automatic covers equipped with a DELTA drive shaft. If
you have another type of drive shaft, please contact us.
- The motor has been designed to fit all DELTA throughwall flanges, model 1998 or later.
Use an adapter for models older than 1998.
- As a rule, the AQUANAUT motor must be operated with a AQUANAUT control panel. Any
use of the motor without the AQUANAUT control panel is dangerous and not recommended.
- The motor has an IP65 rating, this means that it is protected against splashing but not
submersion. The motor must therefore be installed in a pit fitted with a drain and a sump
pump. The pit must be sized in accordance with the DELTA civil engineering diagrams.
- The key switch box must be installed in a location that provides an unobstructed view of the
pool.
- AQUAMAT 3001 motor with connection box
- AQUAMAT control panel
- Water sling
- Motor pin
- U-shaped pin
- Small electrician's flat head screwdriver
- Philipp's screwdriver
- Wire stripper
- Wire clipper
- Utility knife
- Percussion drill with Ø 8 drill bit for concrete
SAFETY•INSTRUCTIONS
. For slat aprons with a larger surface area, use a PL3 motor.
MATERIALS PROVIDED
TOOLS REQUIRED
11/16
2014/05 - Indice de révision : D - code : 0034401