Cleaning Of The Butter Churn; Warranty; Warranty Is Not Valid In Following Cases - Janschitz FJ 10 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

With the right prepared cream, time for producing the butter is approximate 20 minutes.
When the butter is finished, stop mixing. Empty the buttermilk through the outflow on the
bottom part of container. Close the outlet with the clip and add cold water in the contai-
ner through the hole in the cover. Start mixing on speed 1 or 2 for a few minutes. Water
gets white color. Empty this water through the outlet. This treatment cleans (taste of
fermentation) and cools the butter. This process can be done several times.
After that, open the cover and remove the driving group in opposite direction like it is
assembled. For this please take away first the black rubber, which is situated in the middle
of the cover. Air comes now inside the container and you can take away easier the cover
through this opening. Never try to take away the cover on the side by using the safety
spring. In this case you damage the cover and the safety spring as well.
Hold the mixer and turn it in direction of driving holder. In this way the mixer is free, and
it can be removed from container. The butter usually stays on the mixer or stays in lump
in container.
Reasons for a longer duration of the butter production process:
• Too much cream in the container (level of cream must be under axe of mixer)
• Temperature of cream is too high or too low (should be between 12°C and 15°C)
• Preparation of the cream is not correct (temperature and ripening time are wrong)
• Too low content of fat in the cream (in sour cream -32% in sweet cream - 45 % fat)

CLEANING OF THE BUTTER CHURN

It is prohibited to clean the driving group with water of wet duster. Clean the body with a
dry and soft towel. The container is cleaned with hot water, best is to add liquid detergent.
The container washer is cleaned with hot water, take care that you do not extend it.
Cover with black rubber cork is cleaned with warm water (max 50 °C), add some liquid
detergent.

WARRANTY

We declare, that:
• butter churn FJ 10 will work perfectly in warranty time, if it will be used in accordance
with purpose of device.
• we will remove all defects on device in warranty time if necessary
WARRANTY IS NOT VALID IN FOLLOWING CASE
• if instructions for use are not considered
• if reparation is done by non-authorized personal
• if non original spare parts are build in
• damage, which is made for mechanical beat, or if water comes in the driving group.
Reparations in warranty time:
All repairs in warranty time can be enforced only with correctly full-filled bill from seller
where this product was bought.
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières