Mitsubishi Electric PEH-P400 Manuel D'installation page 15

6 Mode No. selection
Select the mode No. you want to set with the F [
7 Select the setting contents of the selected mode.
When the G [
MENU] button is pressed, the current setting No. flashes. Use
this to check the currently set contents.
Setting No. display
8 The contents set at steps 3 to 7 are registered.
When the E [
] button is pressed, the mode No. and setting No. flash and registration begins. The flashing mode No. and setting No. change to a steady light and
setting ends.
* When "– –" appears at the mode No. and setting No. displays and "
Make sure there are no noise sources near the transmission line.
9 To select more functions, repeat steps 3 to 8.
0 End function selection.
Press and hold down the A [FILTER] and B [TEST] buttons at the same time for two seconds or longer.
After a while, the function selection display disappears and the remote controller returns to the air conditioner off display.
* Do not operate the air conditioner from the remote controller for 30 seconds after the end of function selection.
Note:
When the functions of an indoor unit were changed by function selection after the end of installation, always indicate the set contents by entering a
mark in the appropriate check field of Table 1 and Table 2.
<Wireless remote controller type>
CHECK
ON/OFF
E
FAN
MODE VANE
CHECK LOUVER
F
TEST RUN
SET RESET
1
CHECK
3
CHECK
TEMP. ( ) and (
Mode No. display
Setting No. 1 = 240 V
" flashes at the room temperature display, communication is probably abnormal.
TEMP
C,D
AUTO STOP
AUTO START
h
A
min
B
CLOCK
2
CHECK
4
CHECK
)] buttons. (Only the settable mode numbers can be selected.)
Mode No. 04 = Power voltage
Select the setting No. using the F [
Setting No. 2 = 220 V, 230 V
Changing the power voltage setting
Be sure to change the power voltage setting depending on the voltage used.
1 Go to the function select mode
CHECK
button F twice continuously.
Press the
(Start this operation from the status of remote controller display turned off.)
is lighted and "00" blinks.
CHECK
button C once to set "50". Direct the wireless remote controller
Press the temp
toward the receiver of the indoor unit and press the
2 Setting the unit number
Press the temp
wireless remote controller toward the receiver of the indoor unit and press the
min
button B.
3 Selecting a mode
Enter 04 to change the power voltage setting using the
Direct the wireless remote controller toward the receiver of the indoor unit and
h
button A.
press the
Current setting number:
4 Selecting the setting number
C and
Use the
V, 230 V). Direct the wireless remote controller toward the sensor of the indoor unit
h
button A.
and press the
5 To select multiple functions continuously
Repeat steps 3 and 4 to change multiple function settings continuously.
6 Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and press
button E.
the
Note:
Whenever changes are made to the function settings after construction or
maintenance, be sure to record the added functions with an "
"Check" column provided on the chart.
TEMP. ( ) and ( )] buttons.
h
button A.
button C and D to set the unit number "00". Direct the
C and
1 = 1 beep (one second)
2 = 2 beeps (one second each)
3 = 3 beeps (one second each)
D buttons to change the power voltage setting to 02 (220
or other
D buttons.
", in the
15