Use - DS Produkte 00812 Mode D'emploi

EN

Use

PLEASE NOTE!
■ Do not use the device if it has malfunctioned or been dropped in water. Have it
checked in a specialist workshop before using it again.
■ The device should only be used if it has been correctly assembled.
■ Do not move the device during operation. Ensure that it is stable!
■ Keep the device clean.
■ After 15 seconds of constant operation, pause for 15 seconds to ensure that the
motor is not overloaded.
1. Wash and halve the fruit.
2. Place one half of the fruit on the press cone (7) and press it down. This causes the
device to switch on and the press cone rotates. The press cone changes the direction
of rotation if there is too much pressure.
The juice which is squeezed out runs through the strainer (2) into the juice contain-
er (5). The fruit pulp is trapped in the strainer.
3. Stop applying pressure to stop the device.
4. If you are processing fairly large amounts of fruit, take the strainer out from time to
time and remove the fruit pulp so that the juice can run down into the juice container.
5. After squeezing the fruit, twist the juice container anticlockwise and take it off the
motor unit (4).
6. Remove the strainer and pour the juice into a glass or similar vessel.
7. Clean all parts of the device immediately after use so that the fruit pulp does not dry
on (see the "Cleaning and Storage" chapter).
14
1. Place the motor unit (4) on the kitchen unit or another dry,
clean, fl at work surface.
2. Plug the shaft (3) into the motor unit as shown here.
3. Place the juice container (5) over the shaft onto the motor unit
and twist it clockwise until it engages in place.
4. Place the adapter (6) onto the top end of the shaft.
5. Insert the strainer (2) into the juice container.
6. Place the press cone (7) onto the adapter.
7. Fully unwind the connecting cable and plug the mains plug
into an easily accessible plug socket.
The device is now ready for operation.
The device is disassembled in the reverse order.