Specifications - Uniden MHS75 Guide D'utilisation

Problem
I can't hear anything
from the speaker.
Noise comes out of the
speaker all the time
I can transmit, but no
one can hear me.
I'm not getting hazard
alerts.
The display flashes,
and I don't know why.
Where can I find my
radio's serial number?

Specifications

General
Channels
Freq. Control
Freq. Tol.
Oper. Temp.
Antenna
Microphone
Display
Speaker
Power Source
Size (without antenna)
Weight
E-18
Things to Try
Adjust the squelch level; it is probably too high.
Adjust the squelch level; it is probably too low.
Check your UIC channel settings: does the area
you are in use different channel assignments?
Make sure Weather Alert Watch is turned on.
The channel number on the display will flash if
the radio is in a watch mode or in scan mode.
Try turning off scanning, Weather Alert Watch,
Triple Watch, or Dual Watch (see page 6).
The serial number is on a plate inside the
battery compartment.
All US/International/Canada marine
channels
10 Weather channels
PLL
Transmit: 1.5 PPM (at 25°C)
Receive: 1.5 PPM (at 25°C)
-4°F (-20°C) to +122°F(+50°C)
Flexible Whip
Built-in Electret type
Liquid Crystal Display
8Ω 0.5 Watt
Rechargeable Lithium Ion Battery
7.4V 1040 mAh
4.57 (H) x 2.49 (W) x 1.53 (D) inch
116.2 (H) x 63.3 (W) x 39 (D) mm
10.2 oz (290g) (w/battery and antenna)
Uniden MHS75 Radio Owner's Manual